RS WAS - Rotary shaft seals

Type/Ref.: Rotary shaft seals
Pressure (bar): ≤ 0.05/0.5
Temperature (°C): -40 to +100
Peripheral speed (m/s): ≤ 12

Rotary shaft seal in standard design according to DIN 3760 with an elastomer outer sheath covering a metal insert as well as a spring-energised sealing lip. In addition, the standard design is available with a protective lip (RS WAS) on the air side.

Standard materials

NBR70 Colour: black
Energised spring: non-alloy spring steel according to DIN EN 10270-1
Metal insert: non-alloy steel according to DIN EN 10139

Areas of application

Sealing of rotating machine elements such as shafts, hubs and axles.

Function

The RS WA/RS WAS is a single action rotary shaft seal for rotating or pivoting shafts with optional protective lip sealing action (RS WAS) on the side facing away from the medium, against dirt accumulation from the outside. The elastomer outer sheath provides good static sealing, good thermal expansion balance e.g. in light-metal housings, better sealing with greater roughness and secure sealing for split housings as well as good static sealing with thin fluid or gaseous media.

Media

Good chemical resistance to many mineral oils and greases. Please also refer to our media resistance tables on page 17 of this catalogue.

Operational application limits

Pressure (Mpa/bar): ≤ 0.05/0.5
Temperature (°C): -40 to +100
Peripheral speed (m/s): ≤ 12

Installation

Suitable tools should be used for installation. It is recommended that the installation housing is designed to provide the rotary shaft seal with axial support. Please also refer to our general installation instructions on page 25 of this catalogue.

Remarks

The nominal widths mentioned on the following pages represent the standard dimensions.
Other dimensions and different designs, e.g. double dust protection lip, spiral on the sealing lip, springs or metal cases made of other steel grades can be produced as well as all kinds of special designs. Minimum quantities may be obligatory for dimensions outside of the standard.